The management interface network settings must now be configured, when prompted complete the steps to configure the IPv4/IPv6 address, netmask, gateway for the Management 1/1 interface.
Once complete login to the device from the console. The installation procedure will continue, at some point will confirm that the remained of the installation will take 30 minutes or more, the output from the console will confirm the progress. When prompted enter a new admin password. Login to the device with the default credentials username admin and password Admin123įrom the output below, you can determine the installation process is still underway post login to the console. The system will reboot and will return to the login prompt The system will validate the image, run show detail to confirm progressĪfter a few minutes, run show detail again and confirm the Upgrade State has progressed from Validating Image to Upgrading System.Īfter a period, the console the upgrade will start, and the console screen will provide the output of progress. When prompted to initiate a configuration backup, type yes. Run the command install security-pack version copy the version from the package-vers column in the previous command. The output below confirms the default software image on the device 6.4.0 and the recently uploaded version 7.1.0. The image will download, the screen output will confirm the transferring KB increasing as the image is transferred, once complete the output should confirm completed successfully. Run the command download image sftp://:/. In this example we will use SFTP protocol to download the software package. From the console of the FPR1010 device run the command scope firmware. 
Locate the file in the TFTP/SCP/SFTP/FTP repository.Download the FTD software package from the Cisco website, in this instance FTD 7.1.0 package is called cisco-ftd-fp1k.7.1.0-90.SPA.On the local computer setup, a TFTP/SCP/SFTP or FTP server to download the software package. From the Command Prompt of the computer run ping 192.168.45.45 to confirm connectivity to the FPR 1010 Management interface.Determine the IP address received via DHCP, run the command ipconfig.From the Command Prompt of the computer configure the device has received an IP address from the range 192.168.45.0/24.Connect an ethernet cable from a computer into the Management 1/1 interface of the FPR 1010 device.
The software package will be download from a SFTP server installed on a laptop connected to the Management 1/1 interface. The System IP address is the IP address of the Management 1/1 interface of FPR 1000 device. Connect to the console port of the Cisco FPR device and login.Refer to this Cisco Reimaging guide for more information. This post covers the steps to reimage a Cisco FPR1010 device with FTD version 7.1.0, the same procedure will work on other 1000 series models.
0 kommentar(er)
